INJECTOR REMOVAL TOOL SET VAG

INJECTOR REMOVAL TOOL SET VAG

INJECTOR REMOVAL TOOL SET VAG

Injector Remover / Installer and Service Tool Set for Petrol Injectors installed in VAG Vehicles (Audi / Seat / Skoda / VW)

Covering:- 1.4, 1.6, 1.8, 2.0, 2.7 V6, 3.0 V6, 3.2 V6, 3.6 V6 & 4.2 V8 FSI ENGINES


Instructions:

- Select a puller attachment, slide it onto the injector, use puller screw or slide hammer to safely remove injector

- Once injector is pulled, remove old seal using a small pick or flathead screwdriver (not included) carefully to not damage injector groove surface

- To fit the new seal, place included assembly cone on tip of the injector and slide new seal onto assembly cone, use included assembly sleeve to slide seal onto injector

- Additional tools included for cleaning and installing


Fuel Injector Puller Tool Kit Included:

- Ball type insertion adaptor

- Injector puller large cup type for FSI type injectors.23mm x 76mm

- Injector puller small cup type for FSI type injectors.14mm x 40mm

- Injector puller two legs (thin) for FSI type injectors.19mm x 20mm

- Two cylindrical adaptors. 12mm I.D. 13mm I.D. 40mm long

- Two tapered cone adaptors. 27mm x 4mm taper, 35mm x 7mm taper

- Three knurled stepped adaptors 24mm

- One threaded cup type pulling adaptor. 15mm x 10mm

- One threaded cup type pulling adaptor. 10mm x 8mm

- One spacer bush 19mm O.D x 12mm I.D. x 12mm long

- Slide hammer puller

- Disconnect key 9.5mm